文献类型：期刊文献

中文题名：双针头连续水浴静电纺的电场模拟及其纳米纤维包芯纱结构

英文题名：Electric field simulation of two-needle continuous water bath electrospinning and structure of nanofiber core-spun yarn

作者：周歆如[1];胡铖烨[2];范梦晶[1];洪剑寒[1,3];韩潇[1,3]

机构：[1]绍兴文理学院纺织服装学院,浙江绍兴312000;[2]浙江洁达新材料科技有限公司,浙江绍兴312000;[3]浙江省清洁染整技术研究重点实验室,浙江绍兴312000

年份：2023

卷号：44

期号：2

起止页码：27

中文期刊名：纺织学报

外文期刊名：Journal of Textile Research

收录：CSTPCD、、EI(收录号：20232914419856)、Scopus、CSCD2023_2024、北大核心、CSCD、北大核心2020

基金：浙江省公益技术研究计划项目(LGG20E030002)。

语种：中文

中文关键词：双针头;连续水浴;静电纺丝;纳米纤维包芯纱;电场模拟;针头间距;涤纶;锦纶

外文关键词：two-needle;continuous water bath;electrospinning;nanofiber core-spun yarn;electric field simulation;tip spacing;polyester;polyamide 6

中文摘要：为研究电场变化对皮芯结构纳米纤维包芯纱结构的影响,通过双针头连续水浴静电纺丝法制备了以涤纶长丝为芯纱,锦纶纳米纤维为包覆层,兼具纳米纤维特性和传统纱线力学性能的纳米纤维包芯纱。通过有限元分析软件ANSYS模拟其电场分布,探究了2个针头针尖间距对电场分布及纳米纤维包芯纱结构的影响。结果表明:静电纺丝最大电场强度出现在针尖处,随着针尖间距的增大,电场强度峰值呈现先增大后减小再增大的趋势;当针尖间距为20 mm时,纳米纤维间的黏结较多;随着针尖间距的增大,纳米纤维的形貌更加均匀光滑,其直径呈减小趋势,在针尖间距为80 mm时达到最小值(74.43±10.79) nm;当针尖间距从20 mm增加到60 mm时,纳米纤维包芯纱的孔隙率从20.27%提高到44.08%。

外文摘要：Objective In order to understand the influence of electric field variation on the structure of nanofiber core-spun yarn with skin core structure with two-needle continuous water bath, finite element analysis software ANSYS is used to simulate the change of electric field distribution in the tip spacing. The morphology, diameter distribution, porosity and other structures of nanofiber core-spun yarns with different tip spacing were analyzed. The work aims to establish a theoretical basis for the optimization of process parameters of electrospinning, and provide a reference for the preparation of nanofiber core-spun yarn.Method The continuous preparation of nanofiber core-spun yarn was achieved by using a self-made electrospinning equipment. The nanofiber core-spun yarn with polyester filament as the core yarn and polyamide 6 nanofiber as the coating layer was prepared by two-needle continuous water bath electrospinning method, aiming to acquire special properties combining the nanofiber and traditional yarn. Through the finite element analysis software ANSYS modeling analysis and scanning electron microscope observation, the theoretical and scientific study of the impact of needle tip spacing was carried out on the electric field distribution and nanofiber core-spun yarn structure.Results By simulating the distribution and variation of electrospinning electric field with two needles, it can be confirmed that the maximum field intensity occurs at the tip of the needle. With the increase of tip spacing, the field intensity increases first then decreases and then increases as shown in Tab. 1. When the tip spacing was set greater than 40 mm, the field intensity peak with the increase of the tip spacing and gradually rise. However, considering the restrictions on the size of the electrostatic spinning equipment, and the limitation of fiber sedimentary area, tip spacing should not be too large. The needle tip spacing of 30 mm is better according to the analysis of the Tab. 1. The diameter and morphology of nanofibers can be adjusted by altering the tip spacing. According to the electron microscopy, when the tip spacing is 20 mm, the electric field interference leads to more bonding between the nanofiber. As the tip spacing increases, the interaction between the needles decreases, the morphology of nanofibers becomes more uniform and smooth, and the diameter of nanofibers decreases, as shown in Fig. 5. When the tip spacing is 80 mm, the diameter of the nanofiber reaches the minimum value of(74.43±10.79) nm. It is learnt that two-needle electrospinning requires special attention to the tip spacing while improving the yield of nanofibers to avoid the instability of jet flow caused by too small tip spacing. When the needle tip spacing is increased from 20 mm to 60 mm, the porosity of nanofiber core-spun yarn increased from 20.27% to 44.08%, indicating that the interaction between needles weakened with the increase of tip spacing, leading to improved porosity(as shown in Fig. 7).Conclusion The simulation results show that the maximum field intensity appears at the tip, and the field intensity peak increases first, then decreases and then increases with the increase of the tip spacing. According to the electron microscopy, with the increase of the tip spacing, the interaction between the needles decreases, which can improve the porosity of the nanofiber core-spun yarn, and the diameter of the nanofiber decreases. The structure of the nanofiber core-spun yarn conforms to the changing law of the electric field strength. The results of electric field simulation have guiding significance for the study of the structure of nanofiber core-spun yarns. Due to the problems of electric field interference and equipment limitation in the experimental results, the study of process parameters is of great significance to the electric field variation in the process of electrospinning, which provide reference for subsequent research experiments. The further optimization of equipment and fiber structure and industrial production application are expected to be further discussed in future research.